Mr. Inspector
SAWHORSE
.
CO2 alarms required in new construction only when there is a fuel-fired appliance. But CO2 alarms are required for any permit for alterations, repairs, additions or when bedrooms are added even when there is no fuel-fired appliance on the inside of a existing house. But as you can see a CO2 is not required if just a new mechanical system is installed or repaired, fuel-fired or not, in an existing house per exception.
According to the code per definition, a fireplace is a Mechanical System so if a permit is only for a fireplace a CO2 alarm is not required:
MECHANICAL SYSTEM. A system specifically addressed
and regulated in this code and composed of components,
devices, appliances and equipment.
2015 IRC:
R315.2 Where required. Carbon monoxide alarms shall be
provided in accordance with Sections R315.2.1 and R315.2.2.
R315.2.1 New construction. For new construction, carbon
monoxide alarms shall be provided in dwelling units
where either or both of the following conditions exist.
1. The dwelling unit contains a fuel-fired appliance.
2. The dwelling unit has an attached garage with an
opening that communicates with the dwelling unit.
R315.2.2 Alterations, repairs and additions. Where
alterations, repairs or additions requiring a permit occur,
or where one or more sleeping rooms are added or created
in existing dwellings, the individual dwelling unit shall be
equipped with carbon monoxide alarms located as
required for new dwellings.
Exceptions:
1. Work involving the exterior surfaces of dwellings,
such as the replacement of roofing or siding,
or the addition or replacement of windows or
doors, or the addition of a porch or deck, is
exempt from the requirements of this section.
2. Installation, alteration or repairs of plumbing or
mechanical systems are exempt from the requirements
of this section.
So say a new house was just finished, built with no CO2 alarm required or installed.
A permit for this house just for a new fireplace or a fire-fueled mechanical system does not need a CO2 alarm.
But a permit for this house just for a new electrical circuit will need require a CO2 alarm.
I'm I interpreting this right?
CO2 alarms required in new construction only when there is a fuel-fired appliance. But CO2 alarms are required for any permit for alterations, repairs, additions or when bedrooms are added even when there is no fuel-fired appliance on the inside of a existing house. But as you can see a CO2 is not required if just a new mechanical system is installed or repaired, fuel-fired or not, in an existing house per exception.
According to the code per definition, a fireplace is a Mechanical System so if a permit is only for a fireplace a CO2 alarm is not required:
MECHANICAL SYSTEM. A system specifically addressed
and regulated in this code and composed of components,
devices, appliances and equipment.
2015 IRC:
R315.2 Where required. Carbon monoxide alarms shall be
provided in accordance with Sections R315.2.1 and R315.2.2.
R315.2.1 New construction. For new construction, carbon
monoxide alarms shall be provided in dwelling units
where either or both of the following conditions exist.
1. The dwelling unit contains a fuel-fired appliance.
2. The dwelling unit has an attached garage with an
opening that communicates with the dwelling unit.
R315.2.2 Alterations, repairs and additions. Where
alterations, repairs or additions requiring a permit occur,
or where one or more sleeping rooms are added or created
in existing dwellings, the individual dwelling unit shall be
equipped with carbon monoxide alarms located as
required for new dwellings.
Exceptions:
1. Work involving the exterior surfaces of dwellings,
such as the replacement of roofing or siding,
or the addition or replacement of windows or
doors, or the addition of a porch or deck, is
exempt from the requirements of this section.
2. Installation, alteration or repairs of plumbing or
mechanical systems are exempt from the requirements
of this section.
So say a new house was just finished, built with no CO2 alarm required or installed.
A permit for this house just for a new fireplace or a fire-fueled mechanical system does not need a CO2 alarm.
But a permit for this house just for a new electrical circuit will need require a CO2 alarm.
I'm I interpreting this right?