joetheinspector
REGISTERED
- Joined
- Jan 1, 2010
- Messages
- 152
Are Carbon Monoxide Alarms required to be hardwired? Can they be battery operated?
2009 IRC Section 315
2009 IRC Section 315
-
Welcome to The Building Code Forum
Your premier resource for building code knowledge.
This forum remains free to the public thanks to the generous support of our Sawhorse Members and Corporate Sponsors. Their contributions help keep this community thriving and accessible.
Want enhanced access to expert discussions and exclusive features? Learn more about the benefits here.
Ready to upgrade? Log in and upgrade now.
Carbon Monoxide Alarms 2009 IRC R315
- Thread starter joetheinspector
- Start date
mark handler
SAWHORSE
2010 CALIFORNIA RESIDENTIAL CODE
R315.1.1 Power supply. For new construction required carbon monoxide alarms shall receive their primary power from the building wiring where such wiring is servedfrom a commercial source and shall be equipped with a battery back-up. Alarm wiring shall be directly connected to the permanent building wiring without a disconnecting switch other than as required for overcurrent protection.
Exceptions:
1. In dwelling units where there is no commercial power supply the carbon monoxide alarm may be solely battery operated.
2. In existing dwelling units a carbon monoxide alarm is permitted to be solely battery operated where repairs or alterations do not result in the removal of wall and ceiling finishes or there is no access by means of attic, basement or crawl space.
R315.1.1 Power supply. For new construction required carbon monoxide alarms shall receive their primary power from the building wiring where such wiring is servedfrom a commercial source and shall be equipped with a battery back-up. Alarm wiring shall be directly connected to the permanent building wiring without a disconnecting switch other than as required for overcurrent protection.
Exceptions:
1. In dwelling units where there is no commercial power supply the carbon monoxide alarm may be solely battery operated.
2. In existing dwelling units a carbon monoxide alarm is permitted to be solely battery operated where repairs or alterations do not result in the removal of wall and ceiling finishes or there is no access by means of attic, basement or crawl space.
mark handler
SAWHORSE
joetheinspector
REGISTERED
- Joined
- Jan 1, 2010
- Messages
- 152
Thanks for the reply Mark. Especially the link to the former discussion on this topic.
I am not in California. I am in New Mexico. There is not a NM amendment to R315 so I am going strictly out out of the 2009 IRC Section 315.
The code doesn't say anything about a hard wire requirement. I am not familiar with UL 2034. That doen't require hardwiring does it??
CO alarms do come battery operated. I have one in my house. One time my CO alarm went off. It says on the CO alarm next to the light move to fresh air. So when it went off I took it off the wall and took it out side (problem solved).
I am not in California. I am in New Mexico. There is not a NM amendment to R315 so I am going strictly out out of the 2009 IRC Section 315.
The code doesn't say anything about a hard wire requirement. I am not familiar with UL 2034. That doen't require hardwiring does it??
CO alarms do come battery operated. I have one in my house. One time my CO alarm went off. It says on the CO alarm next to the light move to fresh air. So when it went off I took it off the wall and took it out side (problem solved).
fatboy
Administrator
Unamended IRC CO detectors are not required to be hard wired.
The 2010 California Residential Code mirrors the IRC but R314.6.1 was added to get around most of the requirements. It states that the section is not mandatory in existing R3 and is left to the discretion of the AHJ. In other words, write your own code.
The ICC went too far with the requirement for hardwire and interconnection if there is an attic or crawl space. ICC bumped it's head with requiring compliance when any permit is required. ICC took too big a bite from the apple and the populace choked.
The ICC went too far with the requirement for hardwire and interconnection if there is an attic or crawl space. ICC bumped it's head with requiring compliance when any permit is required. ICC took too big a bite from the apple and the populace choked.
Bryan Holland
Silver Member
I would suggest you review the NFPA 720 - Standard for the Installation of CO Warning Equipment in Dwelling Units. There is a lot of good information that correlates with the ANSI/UL 2034 requirements.