• Welcome to the new and improved Building Code Forum. We appreciate you being here and hope that you are getting the information that you need concerning all codes of the building trades. This is a free forum to the public due to the generosity of the Sawhorses, Corporate Supporters and Supporters who have upgraded their accounts. If you would like to have improved access to the forum please upgrade to Sawhorse by first logging in then clicking here: Upgrades

job built shower pans

C

codeworks

BRONZE MEMBER
Joined
Jun 12, 2011
Messages
579
Location
South Texas
My question has to do with site built, or "job built" shower pans. I saw one a while back, that was the proper material "IAPMO" FLEXIBLE rubber/nylon. There was no blocking between the stud bays to provide "adequate support" for the pan liner prior to the installation of backerboard. Also, I didn't see any corner dams, which seemed odd to me. I was an "observer", so I just observed. I would have been looking for these things, what about y'all? the curb, height etc, etc. was good. slope was ok. Thanks in advance
 
If there is a "IAPMO" label there must be a report on it, find the report. I needs to be installed per the report.
 
You must log in or register to reply here.
Back
Top