darcar
Silver Member
- Joined
- Nov 12, 2009
- Messages
- 129
Depending on the terminology you use, where in the IRC does it address the number of supports under a header?
If a header spans 3 foot or 12 foot or any other length, is there a section in the IRC that addresses the number of cripples required under that header?
Figure 602.3(2) shows a drawing that defines different components and gives sections relating to certain ones, but nothing addresses the trimmers.
If a header spans 3 foot or 12 foot or any other length, is there a section in the IRC that addresses the number of cripples required under that header?
Figure 602.3(2) shows a drawing that defines different components and gives sections relating to certain ones, but nothing addresses the trimmers.