TimNY
SILVER MEMBER
We don't get a lot of commercial construction, so I am going to admit I don't know as much about this as i should.I've attached a pdf of a proposed new bathroom (all the walls depicted in the picture are new). Drawn by me, but taken off a set of plans recently submitted.These are my thoughts, let me know if I'm right or wrong, or if I'm missing anything.1. 604.3.1 clearance around the toilet; 60" wide min, 56" deep min (can the door be located in this 56" depth? I think yes)2 IBC 1109.2.1.6 clear area. This is in ANSi A117.1 somewhere as well?3. Front approach to the sink looks goodNow.. questions..If the door were changed to swing out, anything I should be looking at other than the means of egress requirements?Anything else I am missing on this layout?Taking the whole bathroom out of the scenario and just looking at this door. It appears to me that if you actually did bring a wheelchair in there, you couldn't close the door. Would this be a "hinge approach - pull side" scenario?Thanks,Timaccessible_bath.gif[/attachment:1bjy5npy]
View attachment 1312
View attachment 1312
/monthly_2010_06/accessible_bath.gif.da45fb20eca3e4490d010d09ca8e9803.gif
View attachment 1312
View attachment 1312
/monthly_2010_06/accessible_bath.gif.da45fb20eca3e4490d010d09ca8e9803.gif