• Welcome to the new and improved Building Code Forum. We appreciate you being here and hope that you are getting the information that you need concerning all codes of the building trades. This is a free forum to the public due to the generosity of the Sawhorses, Corporate Supporters and Supporters who have upgraded their accounts. If you would like to have improved access to the forum please upgrade to Sawhorse by first logging in then clicking here: Upgrades

ADA T-stat height

chris kennedy

Sawhorse
Joined
Oct 24, 2009
Messages
1,535
Location
Miami Fla
Is 54" OK for side approach? Would a T-stat in a Bagel joint be subject to ADA requirements? Baths, parking, seating, ect are.

Thank you.
 
No

2010ADASAD

Advisory 205.1 General. Controls covered by 205.1 include, but are not limited to, light switches, circuit breakers, duplexes and other convenience receptacles, environmental and appliance controls, plumbing fixture controls, and security and intercom systems

308.3 Side Reach.

308.3.1 Unobstructed. Where a clear floor or ground space allows a parallel approach to an element and the side reach is unobstructed, the high side reach shall be 48 inches maximum and the low side reach shall be 15 inches (380 mm) minimum above the finish floor or ground.
 
ADA,

1991 standard 54",

2010 standard lowered to 48" effective as of 3/15/12

Q. By lowering the height of a wall mounted thermostat, do you think the furnace would come on more often and use more energy? or it would remain about the same?

Just asking

pc1
 
Pcinspector1 said:
Q. By lowering the height of a wall mounted thermostat, do you think the furnace would come on more often and use more energy? or it would remain about the same?
Doesn't matter...If you allow blacks to use the same drinking fountain as whites are you going to use more water. It is a civil rights law.

Heating---- more

AC ---------less
 
Inspected two FEMA trailers this week, thermostats set at 48" from FF to the center of the stat. Controls were on top of the stat which puts them at 50-1/2".

pc1
 
Are they required to be accessible?

were there ramps?

Are they Single family detached? if so not covered by ADA.....
 
I wonder if it would include the fake ones we installed in large office buildings so the workers thought they had control over the HVAC settings? They did not control anything.
 
mtlogcabin said:
I wonder if it would include the fake ones we installed in large office buildings so the workers thought they had control over the HVAC settings? They did not control anything.
Equal access,,,,,
 
north star said:
= = =Placebo environmental controls, ...interesting concept!



= = =
Years ago my dad was a manager in a photoprocessing plant and the people doing the printing in cubilcle complained of too hot or too cold in adjacent cubes--he bought a box of cheap thermometers and asked each woman what temp they wanted their cubicle, gave them the appropriate thermometer, and the complaints ended.
 
Max 48" high. It can be higher if it is secured in a locked box and only accessible by maintenance staff.
 
Min&Max said:
Max 48" high. It can be higher if it is secured in a locked box and only accessible by maintenance staff.
Where is that in the code? ADA?

what if the manager is a wheeler?

Why do we always try to go around the code?

2010 ADASAD

Advisory 205.1 General. Controls covered by 205.1 include, but are not limited to, light switches, circuit breakers, duplexes and other convenience receptacles, environmental and appliance controls, plumbing fixture controls, and security and intercom systems
 
Min&Max said:
Max 48" high. It can be higher if it is secured in a locked box and only accessible by maintenance staff.
Correct. That is the exact response given by an ADA instructor at a seminar that I attended a while back. If it located in a locked box that is controlled by maintenance staff that must be ambulatory to perform their daily duties, the thermostat can be located above the normal 48" max reach requirement.
 
mark handler said:
Where is that in the code? ADA?what if the manager is a wheeler?

Why do we always try to go around the code?

2010 ADASAD

Advisory 205.1 General. Controls covered by 205.1 include, but are not limited to, light switches, circuit breakers, duplexes and other convenience receptacles, environmental and appliance controls, plumbing fixture controls, and security and intercom systems
Better question; Why do some always try to interpret the code to be more restrictive than it actually is?
 
incognito said:
Better question; Why do some always try to interpret the code to be more restrictive than it actually is?
WHAT PART OF THE Department of Justice Advisory 205.1, IS "MORE RESTRICTIVE" than it actually is?
 
Last edited by a moderator:
incognito said:
Correct. That is the exact response given by an ADA instructor at a seminar that I attended a while back. If it located in a locked box that is controlled by maintenance staff that must be ambulatory to perform their daily duties, the thermostat can be located above the normal 48" max reach requirement.
If the "ADA instructor" told you something incorrect, for $0.45 you could buy a first class postage stamp.
 
Top