• Welcome to The Building Code Forum

    Your premier resource for building code knowledge.

    This forum remains free to the public thanks to the generous support of our Sawhorse Members and Corporate Sponsors. Their contributions help keep this community thriving and accessible.

    Want enhanced access to expert discussions and exclusive features? Learn more about the benefits here.

    Ready to upgrade? Log in and upgrade now.

HC ramps frost protection

fcllc

REGISTERED
Joined
Sep 5, 2014
Messages
26
Location
Connecticut
Handicap ramps on the exterior of a new building, ramps will have a switch back and run against each other, so we will have a wall under the ramps. My question is do the walls need to be frost protected?
 
yes its a permanent installation, i wasn't sure if i needed frost protection on the wall under the ramp side since the 4" concrete ramp is on grade on the other side. thanks
 
If it is attached to the building, then certainly yes.....the thing you don't want is one heaving and one not...

We don't have this in the IBC.......Just IRC

R311.5.1 Attachment. Exterior landings, decks, balconies, stairs and similar facilities shall be positively anchored to the primary structure to resist both vertical and lateral forces or shall be designed to be self-supporting. Attachment shall not be accomplished by use of toenails or nails subject to withdrawal.

So if it is not "attached" physically to the building it might not need it, other than it sounds like there might be a retaining wall factor to consider....?
 
Last edited by a moderator:
If it is directly attached (not adjacent) it would have to be frost protected like the building to not cause damage to one or the other from heaving, any place after that (with a non-connected joint)would be fine to break the frost protection as long as there was not other structural concerns.....Not any different than a sidewalk other than the potential "retaining wall" issue mentioned above...
 
that makes sense, so on the switch back portion of the ramp the tallest part of wall is 42" (2-21' ramp runs) i should consider that a retaining wall?
 
fcllc said:
that makes sense, so on the switch back portion of the ramp the tallest part of wall is 42" (2-21' ramp runs) i should consider that a retaining wall?
What is the slope of the two runs for the ramps?
 
Back
Top