Name the violation(s)

[jar546]

What do you see here under the IPC or IRC for a plumbing violation or violations?

 

[steveray]

Fall before vent "s trap", no test, fireblocking....

 

[Mr. Inspector]

Just inspected a two family home with 5 bathrooms and two kitchens that a flipper has. Every drain was like the one on the right. "What do you mean not vented, there is a pipe sticking out of the roof".

 

[McShan]

Length of stand pipe on washer connection?
Number of studs drilled through at washer?
Sanitary Tee on its back at washer?

 

[ICE]

Not much in the way of securing the waste and copper pipe.

 

[steveray]

Length of stand pipe on washer connection?
Number of studs drilled through at washer?
Sanitary Tee on its back at washer?

I thought about the standpipe height, but couldn't say for sure....That tee should be the vent...

 

[Keystone]

Not an "S" trap. An "S" trap is a trap in configuration of literally an S, this pictured configuration has the trap weir below the vent also the WYE is not compliant. Could've used a double cross tee or 2 separate tees. Support 1.5" cross arms. Pex appears reasonably supported.

 

[Keystone]

Now that I look close, the copper stubs should be soldered.

 

[Keystone]

And for good measure, even though I can't see the entire wall height, mid wall Poe restraint.

 

[Keystone]

Sealing floor penetrations

 

[Keystone]

Penetration of pex thru floor, size & support

 

[north star]

$ ~ $


Can't tell for sure, but the wood does not appear to be pressure
treated "in contact" with the concrete...........Also, both Lavatory
drains look flat ( i.e. - not sloped ).........In looking at the "increased
size" of the Photo, how are the sole plates on both sides of these
Lavatories fastened to the concrete ?


$ ~ $

 

[JBI]

north star - The deck is OSB, not concrete...

 

[jar546]

$ ~ $


Can't tell for sure, but the wood does not appear to be pressure
treated "in contact" with the concrete...........Also, both Lavatory
drains look flat ( i.e. - not sloped ).........In looking at the "increased
size" of the Photo, how are the sole plates on both sides of these
Lavatories fastened to the concrete ?


$ ~ $

Concrete?

 

[north star]

$ ~ $


Thanks for the clarification Big John !


$ ~ $

 

[SCBO1]

Can someone tell if its missing FHA plates or stud guards, I can't tell from the photo?

PEX is suppose to have some support, don't see in little black pipe clamps.

$50.00 bill not attached to stud for building inspection?

I give up, can't see, magnifier malfunction.

 

[linnrg]

yesterday

 

[FLSTF01]

P-trap is too close to tee, creating an S-trap. No nail plates.

Also add: over notched stud/no nail protection at that huge notch at the bottom of the stud.

 

[Keystone]

Jar, inquiring minds want to know??????