BSSTG
Gold Member
Greetings all again,
I was just informed of a project involving a new x-ray machine to be installed. Being an electrician I don't have an issue with electrical. However, I don't know what requirements there are insofar as the construction of the room with the lead lined drywall etc. All I've seen is a sketch of the room thus far. the sketch did indicate lead and wall thickness. I would expect the manufacturer specs will have a lot of info on the installation but I haven't seen that either. Being here in Tx. I figure that there is some state oversight. I'm not even sure about that through. This is one subject I am really ignorant on.
Input is always welcome and appreciated.
thanks
BS
I was just informed of a project involving a new x-ray machine to be installed. Being an electrician I don't have an issue with electrical. However, I don't know what requirements there are insofar as the construction of the room with the lead lined drywall etc. All I've seen is a sketch of the room thus far. the sketch did indicate lead and wall thickness. I would expect the manufacturer specs will have a lot of info on the installation but I haven't seen that either. Being here in Tx. I figure that there is some state oversight. I'm not even sure about that through. This is one subject I am really ignorant on.
Input is always welcome and appreciated.
thanks
BS