I remember a discussion somewhere, but cannot find it. The side grab bar at a toilet ... how is the finger clearance affected by a recessed TP dispenser?
Specifically, if the centerline of the bar is 36” and the top of the dispenser is 30” ... problem? Looking at the mfgr spec sheet ... bobrick in this case ... the flange extends 1/4” from the wall, and then about half the dia of a full roll of TP could extend out.
Specifically, if the centerline of the bar is 36” and the top of the dispenser is 30” ... problem? Looking at the mfgr spec sheet ... bobrick in this case ... the flange extends 1/4” from the wall, and then about half the dia of a full roll of TP could extend out.