• Welcome to The Building Code Forum

    Your premier resource for building code knowledge.

    This forum remains free to the public thanks to the generous support of our Sawhorse Members and Corporate Sponsors. Their contributions help keep this community thriving and accessible.

    Want enhanced access to expert discussions and exclusive features? Learn more about the benefits here.

    Ready to upgrade? Log in and upgrade now.

An average day

This is just north of Chico, Ca. They must not be in a recognized seismic zone. There have been earthquakes in the area.

22223518696_26b78a1bb9_o.jpg

I would have a hard time working in an area that doesn't have earthquakes....things look like they are incomplete.

22062711749_64470bef83_b.jpg
 
Last edited:
MASSDRIVER said:
We should go to Sierra Nevada brewery and get smashed and tell lies about how good we are. Brent.
Click to expand...
I am back home in southern Ca. I used to put away plenty of beer with a guy named Brent when I worked in Chico. Nowadays it's more like a chocolate shake at Denny's.
 
ICE said:
I am back home in southern Ca. I used to put away plenty of beer with a guy named Brent when I worked in Chico. Nowadays it's more like a chocolate shake at Denny's.
Click to expand...
The world is a cruel place.

Brent. (The other one).
 
22306301856_3a8dfd8204_b.jpg

This is my fault. I should have caught this at rough inspection. There is no way to place the laundry equipment without the dryer sitting in front of the panel. I wrote a slew of corrections on this job. The owner tried to have me replaced...more than once. And now this. I told him that I made the mistake and I'm not going to make him correct it. That's awful huh. The damned thing won't be dangerous until someone has to work on the inside of the panel but that's no excuse for missing it. I just looked at the file...45 corrections have been written so far.
 
Last edited:
JCraver said:
Was one of them that guardrail in the background?
Click to expand...
That didn't take long at all. And yes it is at 28" high at the nose of the tread.
 
Last edited by a moderator:
Okay, so you're there for a sheathing inspection....what catches your attention?

22359169112_127d7f56a5_b.jpg
 
Last edited:
I almost always have to dig through crap to see the work. Sometimes it's like I'm on an alien planet.

When there are slotted washers there shall be a cut washer under the nut.

21749683043_b960a43f1e_b.jpg
 
Last edited:
There's a lot of paint on that pipe.

21750063893_65f741a4b4_b.jpg

This guy had it fixed in no time. Now had he been a kilt aficionado, and that's not what you are thinking fatboy, well I would have said get it fixed and call me back. But no....this guy was almost in pants so I stuck around while he fixed it. It was a little bit nerve wracking when a helicopter started circling.

22183436368_75e5fc8e76_b.jpg
 
Last edited:
mtlogcabin said:
Is that black soot, or burnt galvanize around the "B" vent opening?
Click to expand...
You're pretty darn good for an desk jockey. It is from soot. I brought the lady outside and showed it to her. She said that it is from two years ago when the wall furnace malfunctioned and was repaired. I couldn't get close to it because the roof is too steep for me to walk.

The lady was different than most. She reminded me of a someone from my past.

Years ago I owned a Union 76. I had three bays of mechanics working 24 hours a day. One day a lady pulled up to the full serve island. I worked that island quite often and she was as white as Conarb. She had jet black hair, too much red lipstick and oh my gosh was she wrinkled. Well she looked like a poorly prepared corpse. Turns out that she became a regular customer. I gave her the knickname Dead Lady.

One winter day she drove up and asked if we could do a brake job on her car. I went into the shop and said, "Can any of you mechanics do a brake job on the Dead Lady's car. A few of them turned and looked at me but nobody said anything. From behind me I heard her say, "The Dead Lady?"
 
Last edited by a moderator:
My day for water heaters. I had an inspection request for a water heater inspection at an apartment complex but the permit and the inspection request slip do not have a unit number. So I went looking. I found the three boilers agua caliente. But the one I needed was in an apartment.

22407677062_9db299a907_b.jpg

A friendly tenant took me around the each apartment until a lady said, Si Senior I have boiler agua caliente new. It is this one.

22232933130_88d16ca590_b.jpg
 
Last edited:
MASSDRIVER said:
/\ People just can't seem to get that one right.Brent.
Click to expand...
This is the hanger that is called out on the plans.

22233252620_aec55405c7.jpg

Obviously that would not work so I suggested that additional pier and posts would solve the problem. But they left out the 18"x18"x18" footing which they have on all of the other posts.

22407723562_fd728824e1_b.jpg
 
Last edited:
You must log in or register to reply here.
Back
Top