fatboy
Administrator
I would be pi$$ed as hell if someone did that to my, what appears to be new, shingles.
Just sayin........
Just sayin........
Last edited:
Looks like some kind of trim piece. To hide the mounting brackets.
Wish they had to here.and they have to do some Cont. Ed
That is a wind deflector. It is aluminum. It is not bonded to any ground.ICE, what is that channel on the very front side of the panels down by the roof edge?
What would you say is the estimated cost from a plan review screen, review software, permitting software, field I-pads etc.?
Since do not see a edit button, forgot to comment about the fine roof jack install, & roof shingle patching, comp roofs are pretty easy to do a nice job cutting in roof jacks into, which they failed miserably by using wet patch, & mixing architectural & 3-tab shingles is always a nice touch, a nightmare for whoever paid a large sum to have it done.
Well then, it appears that the person in charge has overstepped their bounds with this one. While there are ways to go about transforming some service panels to a sub-panel, not entirely legal mind you but there are ways.....This is not one of them. Does anyone know of a UL listing for a meter socket bypass. What Standard would apply? I am not 100% sure that there is no listed meter socket bypass. I am convinced that if there is...one, it's not this one and two, it would be for a temporary use.Those meter main panels are usually listed for use as service equipment only, with a permanently bonded neutral, so am assuming someone added the insulated neutral. You going to let it fly? What did they use to jumper the meter jaws? Have seen a kit made for the purpose but was not insulated.
Looks like the mast used to be to the right and lower than the current location. About where the half-moon cut is in the shingle. And then they used 3-tab to patch the old hole., forgot to comment about the fine roof jack install,
I think milbank makes one...ran across it once....Does anyone know of a UL listing for a meter socket bypass. What Standard would apply? I am not 100% sure that there is no listed meter socket bypass. I am convinced that if there is...one, it's not this one and two, it would be for a temporary use.
Mtlog,Shouldn't the wire with the red marking be on the left and the black on the right isn't that the correct way to do it? Not sure if it is code or just industry standard
View attachment 7245